Rms-technologies IMDP 23 W/ POLE DAMPING TECHNOLOGY*NEW* Manual de usuario descargar pdf (Pagina 19)

RMS Technologies Page 19 Version 1.04

IMDP23/IMDEP23 Manual 8/4/2010

Figure 20: Connection Schematic – Connecting to a Controller

Connecting the Power

The IMDP23 requires a supply voltage of +12-75 VDC. First, connect the positive end of the

power supply to Power (Pin 1), and then connect the negative of the power supply to the

Ground (Pin 2) on the IMDP23.

WARNING! Be careful not to reverse the polarity from the power supply to the driver.

Reversing the connection will destroy your driver and void the warranty.

Connection Schematics

Using external 5VDC supply for optos:

If using an external 5VDC supply,

connect the positive (+) terminal

to the Silverpak’s opto supply

input, PIN 7.

If using a signal generator,

connect the 5VDC supply ground

terminal to the negative line of

the generator.

Figure 21: Schematic with 5VDC

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Rms-technologies IMDP 23 W/ POLE DAMPING TECHNOLOGY*NEW* Manual de usuario Pagina 19