Rms-technologies IMDE17 INTEGRATED MOTOR + DRIVER + ENCODER Manual de usuario descargar pdf (Pagina 10)

RMS Technologies Page 10 Version 1.04

IMD17/IMDE17 10/1/2007

6. GETTING STARTED

In order to properly connect your new IMD17 Unit, first take a look at Figure 4, below.

Here’s a list of the parts needed to make the motor run:

• +12 to 24 Volt Power Supply

• Additional +5 Volt Power Supply

• Function Generator

1. Ensure that the IMD17 is not connected to the Main Power Supply until the

following procedures have been properly carried out.

2. Connect Pin 8 to the Positive Terminal of the +5 VDC Power Supply.

3. Connect the Negative Terminal of the +5 VDC Power Supply to the Negative

Terminal of the Signal Generator. This will be referred to as the Signal

Ground.

4. Connect Pin 1 and Pin 6 to the Positive and Negative Terminals of the Main

Power Supply, respectively.

5. Adjust the Frequency of the Signal Generator to achieve the desired

operating speed.

Figure 4: Connections Diagram

WARNING! DO NOT DISCONNECT THE DB-9 CABLE FROM THE IMD17 UNIT WHILE

POWER IS STILL BEING SUPPLIED. THIS MAY CAUSE DAMAGE TO THE INTERNAL

DRIVER BOARD.

WARNING! If you do not have a +5 VDC Power Source, use a Resistor in series to

limit the current of the opto isolators. See following page for Resistor values. If

the current exceeds 10 mA, the opto couplers cease to function.

1 2 ... 5 6 7 8 9 10 11 12 13

Sin comentarios

Rms-technologies IMDE17 INTEGRATED MOTOR + DRIVER + ENCODER Manual de usuario Pagina 10