Rms-technologies IMCE23 INTERGRATED MOTOR+CONTROLLER +DRIVER+ENCOD Manual de usuario descargar pdf (Pagina 18)

R356 Controller & Driver Page 18 Version 1.06

RMS Technologies 2/17/2010

LED or other output

The two I/O lines, pins 2 & 10, can drive an external device such as solenoids, LED’s,

or switches. The bidirectional I/O’s are switches to ground internally, and therefore

need to be connected to the +V of the power supply. Below is a recommended

connection for lighting an LED with 20 mAmps:

Upon entering command /1J0R, both pins 2 & 10 will output 1 Amps. The 1.2k ohm

resistor will limit the current to 20 mAmps into the LED. Select any ohm value to

limit your current based on the device that is connected to the output. I/O’s are

24VDC tolerant.

Optical Sensor

Figure 11: Opto Sensor Connection Schematic

Use the following table to solder the corresponding wires.

Optical Sensor DB15 Cable Pin #

Green Æ Green/white 12

Black Æ Green/white 12

Red Æ Yellow/white 6

White Æ Orange/white 7

Pin 2

or 10

output

1 2 ... 13 14 15 16 17 18 19 20 21 22 23

Sin comentarios

Rms-technologies IMCE23 INTERGRATED MOTOR+CONTROLLER +DRIVER+ENCOD Manual de usuario Pagina 18